INSTRUCTIONS - SPLICING BUNDLES
1. CUT AN OPENING Cut an opening in the microduct using the Melbye Cable Stripping Knife.
1
2. SLICE ALONG THE MICRODUCT Make a slice along the length of microduct using the Melbye Rachetting Duct and Cable Slitter.
2
3. PULL OUT INNER MICRODUCT Pull out a loop of microduct.
3
4. CREATE SOME SLACK Use the Melbye Cable Stripping Knife to pull out enough microduct to insert the Melbye Plastic Pipe Cutter underneath.
4
5. MAKE A CLEAN CUT Use the Melbye Plastic Tube Cutter 3-12mm (1649192) or the Melbye Tube Cutter in Steel 12-25mm (1662506) to cleanly cut the microduct.
5
PUSH TO FIT
6. CONNECT THE MICRODUCT
Use a coupler to connect the two microducts together. Push firmly to fit.
6
PULL TO CHECK
7. CHECK CONNECTION Pull each duct away from the coupler to check the fit is correct.
7
15
Powered by FlippingBook